**Nevermind the motherboard was faulty. Got a replacement and everything is A-OK**

This new pc I got just not happening. I don't claim to be an expert builder, but I have built about 5 in my time with no problems, but after blowing a PSU its really knocked my confidence for 6.

So I did everything again, made sure mobo sitting right so no shorting out etc. Only thing I can think of is I cocked up the wiring.
So, I'm after opinions on what your interpretation is of the manual diagram and where you would position them on diagram.

Only the PLED + and PLED - are single wires for obvious reasons. the rest are two.

If you can help, then save the pic to your pc, then use MSPAINT! to draw + or - sign on the approapriate areas on where you would place each one (based from the manual diagram) and then re-upload if you can!

Can't tell you how much it sucks to see a flash then a plume of smoke :).

Thanks!